Comnet CWFE8MS/DIN Información técnica Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 75
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
16
3.6 Wiring the Fault Alarm Contact
The fault-alarm contact is in the middle of the terminal-block connector as the figure
shows below. By inserting the wires and setting the DIP switches to “ON” status, it will
detect the fault status of power and port link failures.
The following figure shows an application example for the fault alarm contact.
[NOTE] The wire gauge for the terminal block should be in the range between 12~ 24
AWG.
Insert the wires into the fault alarm contact
1A@24V
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 74 75

Comentarios a estos manuales

Sin comentarios