Comnet LBI-31693B Manual del operador descargar pdf (Pagina 17)

function.

3. Select each channel (one at a time) using the ADD or DELETE switch and

confirm channels included on the scan list. The scan indicators (S, P1, P2)

will light for each channel programmed.

∗ If a Priority 1 or 2 scan channel already exists when

programming a new Priority 1 or 2 scan channel, the old Priority

1 or 2 channel becomes a Non-Priority channel.

USING THE OPTIONAL 8 OR 16 CHANNEL

RADIO (WITH SCAN)

Perform the procedure listed in the paragraph “Using the Optional 8 or 16

Channel Radio Without Scan” on page 13.

SCAN MODE

Press and release SCAN switch to enable the scan function. The scan indicator

should light and the following conditions apply:

∗ Only programmed scan channels will be received.

∗ As long as no signal is being received, the digital display will indicate

the pre-scan selected banner. If S, P1, or P2 indicator is not lit, no

signal will be received on this channel, since it has not been

programmed for scan.

∗ When a signal is received the display indicates the channel received

and the priority level.

∗

Removing microphone from hookswitch locks the radio onto the

received scan channel. Pressing the PTT switch on the microphone

allows transmission on the received scan channel.

∗

Scan resumes, after a few seconds delay, when the microphone is

returned to the hookswitch. Pre-scan channel will again be displayed

and will be the transmit channel if user removes microphone from

hookswitch before another channel is detected.

∗

Channel changes and other normal operations are allowed while off-

hook but will be immediately forgotten when the microphone is placed

on hook.

1 2 ... 12 13 14 15 16 17 18 19 20

Sin comentarios

Comnet LBI-31693B Manual del operador Pagina 17